You are here: Driver Reference > DNP3 Driver > Introduction to the DNP3 Driver > DNP3 Slave Configuration

DNP3 Slave Configuration

To configure ClearSCADA as a DNP3 Slave, you need to create and configure:

  1. DNP3 Slave Channel(s) to define the communication connections between ClearSCADA and the DNP3 master (see Configuring a DNP3 Channel).
  2. A DNP3 Slave Outstation Set to define each group of slave outstations that share the same communications channel (see Configuring a DNP3 Outstation Set).
  3. DNP3 Slave Outstation(s) with which a DNP3 master may communicate, in order to obtain data from ClearSCADA (see Configuring a DNP3 Slave Outstation).
  4. Filtered Value maps for mapping point properties into memory so that they can be accessed by a DNP3 master (see Define the Filtered Value Map Locations, and see Configuring Value Maps in the ClearSCADA Guide to Core Configuration).

If the DNP3 Slave is used for routing comms using a Virtual Terminal, you also need to Configure a VT Service Port Slave.


ClearSCADA 2015 R2