As a minimum, for a SCADAPack controller to become functional (online), you have to configure these features on the SCADAPack Outstation Form, then put the controller In Service and save the configuration:
- The Set to which the controller belongs (Outstation tab)
- The Addressing Mode (SCADAPack tab)
- The controller’s Address (SCADAPack tab)
- The Firmware Type (SCADAPack tab)
- The Point Address Range (SCADAPack tab)
- The DLOG properties (if required) (SCADAPack tab)
- The telephone number of the site on which a PSTN controller is located (PSTN tab)
- The Network properties for a network connected controller (Network tab)
- The Shared properties for a shared controller (Shared tab).
This will result in a functional SCADAPack controller that uses the default configuration settings.